Vallas MálagaFencing & boundary walls
Worker digging a post hole on the set-out line
Blog · Comparisons

DIY fence or professional installer: an honest comparison

Plenty of owners are capable of putting up a fence themselves. Whether they should depends on the fence, the site, the rules and how much time they actually spend in Spain.

ComparisonsLast reviewed: Bauman Raymond Attila

When can doing it yourself make sense?

In short: for short, low, simple fences on level ground, where you have the time, tools and willingness to handle the paperwork yourself.

A short run of light fencing around a vegetable patch, on level, soft ground, with no wall and no neighbour involved, is within reach of a practical owner. The materials are available, the risks are limited and a mistake is easy to correct.

This article is not a DIY guide, and we do not recommend products. It is a way of deciding honestly whether your project belongs in that category or not.

Be realistic about the hidden jobs too: hiring or buying tools for digging and mixing, arranging deliveries to a site you may not be at, getting rid of spoil and offcuts, and repairing the lawn or paving along the line afterwards. On a small project these are manageable; on a long or sloping boundary they quickly become the bulk of the work.

Where does DIY usually go wrong?

In short: in groundwork, alignment, slopes, closed infills and walls – the parts that need experience and equipment.

The hard parts of a fence are not the panels. They are:

  • Setting out a straight, correctly positioned line with consistent post spacing.
  • Digging post holes or trenches in rock, roots or fill.
  • Concrete – mixing, pouring and allowing it to set before loading.
  • Slopes – stepping walls and panels so each section is level and gap-free.
  • Walls – blockwork, starter bars, rendering and caps.
  • Wind – sizing posts and footings for closed infills on exposed sites.

A fence that is a few degrees out at one post is out all the way along. Our how we work page shows the sequence a professional follows, and fence on a low wall shows what a wall involves.

Formwork for the strip footing with starter bars
Formwork for the strip footing with starter bars

Do the rules differ for DIY?

In short: no – the same planning rules apply whoever builds the fence, and the owner is responsible either way.

The town hall does not care who holds the spade. A fence built by its owner must meet the same limits and authorisation requirements as one built by a contractor. Read our permit guide before buying materials. If the fence is on a shared line, the neighbour's agreement is just as necessary; see boundary fences with neighbours.

Is DIY realistic if you live abroad?

In short: rarely – a fence needs several consecutive days on site, deliveries and concrete curing, which do not fit a short holiday well.

A fence is a sequence: set out, dig, pour, wait, build, fit. Each step depends on the previous one, and concrete must set before the next load. Squeezing that into a holiday, while also receiving deliveries and disposing of waste, is hard. Half-finished fences left between visits are vulnerable to weather and theft.

For owners abroad, a professional who can be managed remotely is usually more practical; see our guide on managing works from abroad.

There is also the question of what happens if something goes wrong halfway. A trench left open or posts set but not yet braced can be a hazard for neighbours, pets and passers-by while you are away.

Is there a middle ground?

In short: yes – you can supply the materials and have a professional build the groundwork and install them.

Some owners buy their own panels or slats and ask a contractor to handle the setting out, foundations and installation. We can work with material supplied by the client, after checking what it is and how it fixes. That way the critical groundwork is done professionally and you keep control of the product choice.

If you are deciding between fence types first, see our fence types overview.

BR
Bauman Raymond Attila
Author and person responsible · Last reviewed:
FAQ

Frequently asked questions

Can I build my own fence in Spain?

Yes, subject to the same rules and authorisations as any fence. Whether it is wise depends on the fence and the site.

Do I need a permit if I build it myself?

The same rules apply whoever builds it. Check with your town hall.

Which part of a fence is hardest to DIY?

The groundwork: setting out, digging, concrete and stepping on slopes.

Can I build a block wall myself?

It is skilled work with footings, reinforcement and rendering. Most owners are better served by a professional.

Can you install materials I bought?

Yes, after we check the material and how it is meant to be fixed.

Is DIY cheaper?

You save labour, but tools, waste disposal, time and the cost of mistakes add up. Compare honestly.

Can you fix a DIY fence that went wrong?

Often by rebuilding the base and reusing sound materials. Send photos.

Do you give DIY instructions?

No. We build fences; we do not publish DIY guides or product recommendations.

Is DIY possible during a short holiday?

Rarely for anything beyond a small fence, because of sequencing and concrete setting.

What about a fence shared with a neighbour?

Agreement is needed whoever builds it. See our page on boundary fences with neighbours.

Get a quote

Send photos – get an itemised fence quote

Send photos and the approximate length of your fence line. We reply with questions or a visit, then an itemised quote with no commitment. Owners abroad welcome.